Cable bridge, as the electrical protection system in buildings, has good anticorrosion performance. The cable bridge factory is most familiar with the specific anti-corrosion treatment operation process. Want to understand the anticorrosion process of cable tray, follow us to explore it!

電纜橋架的防腐能力直接影響著產品質量的高低和使用壽命，因此對橋架進行防腐處理是必須的。電纜橋架廠家會(huì )在現場采用砂輪機除銹，其除銹的級別必須達到ST3級，表面經過除銹后，在4小時內涂抹上底漆，當發現有新銹時，還要重新再處理。

The anti-corrosion ability of cable tray directly affects the product quality and service life, so it is necessary to carry out anti-corrosion treatment for cable tray. The cable tray manufacturer will use a grinder to remove rust on site, and the derusting level must reach ST3. After derusting, the surface should be coated with primer within 4 hours. When new rust is found, it should be treated again.

粉刷涂層時，層間要縱橫交錯，每層都要往復的均勻涂抹，不能出現漏漆的現象，因為只有稀釋的規定的濃度，才能更符合廠家的生產標準。我廠在配制時，將涂料攪拌均勻后，使用200目銅絲網過濾使用，當開通后將剩余的涂料密封保存。

When painting the coating, the interlayers should be crisscross, and each layer should be applied evenly and reciprocally. The phenomenon of paint leakage is not allowed, because only by diluting the specified concentration, can it meet the manufacturer's production standards. In the preparation of our factory, after mixing the coating evenly, use 200 mesh copper wire mesh to filter and use, and seal the remaining coating after opening.

我們電纜橋架廠在生產的時候，對溫度有嚴格的把控，溫度一般要控制在12-30攝氏度，在進行質量檢查之前會(huì )行橋架防腐能力的檢測，只有該工序合格才能進行下面的生產工序。

During the production, our cable tray factory strictly controls the temperature. Generally, the temperature should be controlled at 12-30 ℃. Before the quality inspection, the anti-corrosion ability of the cable tray will be tested. Only if the process is qualified, can the following production process be carried out.